Once the arms are free rest the center of the roller tube on something like a six foot.
Rv awning uneven how to adjust.
This would call for the rv awning arm repair.
Realign the rv awning arms and make sure they stay in their position.
Go to the end that has the most roller exposed and pull the material to where it is centered on the tube roll it in and then back out and see that it stays centered.
If the upper arm rail needs to move to the left you want to remove the left screw and pull the awning in the track to the left.
Rv awning tension adjustment step 1.
Give yourself some room.
If the rail needs to move to the right remove the right screw and pull the awning right.
Lower the leading edge or roller tube as close to the ground as possible.
If you look at the roller tube you should have equal distance from where the fabric stops to the end cap on each side.
Lower the awning completely.
Put your awning.
You also need to check the awning chord that is placed along with the screws on the awning rail.
The awning cloth is usually fixed in place by one or two screws that go through the gutter and cloth about 6 from each end of the gutter.
Let s raise that upper section up a bit.
Take them out extend the awning a few feet have someone push on the awning to take the slack of the fabric and then you can slide the fabric in the rail to get it to line up.
Free the support arms.
Only move the awning a half inch at a time till you get it where it needs to be.
Another reason your awning in not retracting good could be the screws on the awning chord.
Mine is located at the top of the front of the awning roll.
If it needs replacing then get that done at the earliest.
How to adjust an rv awning spring first.