I looked and the arm comes as an entire assembly and costs over 500 so it s not worth that.
Rv awning screws pulled out.
So the bracket that holds the awning to the rv got pulled off at the bottom and the lower 2 screws stripped out of the side of the rv.
Three of the four screws were missing and the forth was half way out.
Seems lately a few screws are coming loose in our rv.
I will likely pull over ever 50 miles to check.
It is a 7 hour drive one way so should be an adequate test to determine if the modification worked.
I guess it s a good thing i haven t used the awning much.
Originally the rail on my reflection was fastened to the wall with screws all the way across.
Seal the open holes with silicone before installing the awning bracket.
I replaced all four lag screws with the next size up and a 1 2 longer.
A tornado got my awning last week and when the mobile rv repair had completed installing it he took out his screw gun and started to put a screw into the rail.
If your internal framing consists of aluminum or steel studs instead of wood supports you may have success simply going to a larger 5 16 lag screw as you ve suggested.
Picked up some 12 stainless screws today at the hardware store.
Also the bracket is very slightly bent out at the bottom now.
Gd please get back to us.
I believe a relative of theirs worked at an rv dealer and fabbed it up for them but it didn t look all that difficult.
If you have a better idea please comment below i d like to hear how others fix t.
They are slightly longer than the original awning screws but the same as some of the other screws used on exterior pieces namely the bike rack which has been removed.
Here s my quick fix.
Could probably get all the stuff at home depot.
Hopefully this will do the trick.
After the glue sets simply reinstall the same lag screws after drilling 1 8 inch pilot holes.
My dealer is 160 mi away.
One of the screws is half pulled out and the silicone is split.
I was one of the first to have the horizontal awning rail pull out of the wall.
Friends had theirs pull out just like that.
Which keeps the awning from sliding left or right.
I just looked at my awning today after a 1 week trip and it is also pulling away at the back portion above the door.
There seem to be two issues getting mixed together here.
Here s what i m trying first filled the void behind the wall with liquid nails.
Finally got back out and pulled everything apart found the backers about 1 4 below where they drilled the holes.
I too do not leave the awning out in windy conditions and have only used it a few times.
Is it the horizontal awning rail or the vertical awning arm support that pulled out of the wall.
I asked what the heck he was doing and he said my awning never had the screws put in from the factory.
