Rv Awning Motor Maintenance

Remove the bad motor and replace it with the new one.

Rv awning motor maintenance.

Tips to maintain your rv awning. I tried the awning using it and it worked. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. If that does not happen then the motor has gone bad.

By doing this the motor should start to operate and extend or retract the awning. Our large 21 foot dometic 9100 rv power awning is made out of vinyl and has held up very well after 4 years of full time rving. Here are seven tips for regular rv awning maintenance. Inspect pull strap slide pins rv awning motor if its electric awning.

Ultraviolet rays from the sun will also take their toll on your awning. Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. While you are attaching your awning make sure not to take the end caps out. Keep the water temperature less than 100 degrees fahrenheit.

If the awning is not appropriately set the chances of getting new tears and holes will increase significantly. I disassembled the control panel and swapped the slide out room switch it uses the same switch with the power awning switch and the fault swapped as well. To wash your rv awning simply hose it off. You yourself can replace most parts of the awning apart from few things like fabric and awning arms.

Electric rv awning operation is simple enough and easy to maintain. This told me the motor and wiring to the awning was good. Protect your rv awning from the damaging effects of uv radiation. There is no purpose to take them out unless you want to replace the awning.

Rub down the rails pulley rollers and retracting arm to make sure they are not sticking due to friction rust or dirt. There can be several reasons for that and a repair man should be able to check on that. The manual advises using a mixture of cup bleach cup dishwashing liquid added to 5 gallons of water. Repairing the rv awning power switch.

This will work for both acrylic and vinyl awnings. Step 3 fix warped rails. Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have. One way to repair a motorized awning is to simply lubricate the working parts with some machine oil.

Always let the awning air dry don t use heaters.