Roofing Valley Transition

With a clean valley you can lay down some peel and stick roofing membrane.

Roofing valley transition.

Best practices for sealing the metal roof valley vary based on the slope of the roof. The lower roof unavoidably slows down water drainage and when the valley is clogged a significant amount of water coming down that valley will tend to spread out and back up under the shingles. Take care not to place any fasteners in the exposed center area of the metal flashing. Cut the panels from the ground instead of on the roof to avoid damaging the roof with the debris.

Valleys are typically found where gable dormer roofs meet the main roof or when a house has angled wings or additions where two roof sections in different planes meet. First clean the debris out of the valley including sawdust nails and whatever else is in there. Low slope roofs slope less than 3 12 use tape sealant between the valley trim and the panel. Fold the top over the roof ridge and cut the bottom along the drip edge metal.

If repairs are needed the contractor has to remove and then reweave multiple shingles to replace a single one. At the roof transition shown in. Valleys are prone to collecting leaves particularly if someone sets up an antenna at the base of the valley. In order to shingle this kind of roof valley a roofing professional has to install both roof faces at the same time which is quite slow.